Stump Grinding in Town 'n' Country, FL

Town 'n' Country has a lot of mature trees on suburban lots, and a lot of stumps left behind when those trees come down. We grind them below grade so you can plant, sod or build over the spot. We serve Town 'n' Country from Clearwater, FL.

Stump grinding on Town 'n' Country lots

Town 'n' Country sits in western Hillsborough County, about 12 miles northwest of downtown Tampa. Before the 1950s it was mostly natural areas and cattle farms. From 1958 to 1978, nearly 8,000 single-family homes and townhouses went up here, and the trees planted alongside them are now old. When one of them comes down, the stump stays, and so do the roots under the lawn.

A grinder cuts the stump into chips with a spinning toothed wheel, usually a few inches below the soil line. It is faster and less disruptive than digging, and it leaves the ground close to level. Here is what tends to matter on a lot in this area.

Older lots with fences and tight side yards

Many homes here were built close together, with fenced back yards and narrow side gates. Stump grinders come in different widths, so access decides which machine we bring. Before we quote, we want to know how wide the gate is and whether anything is in the way, such as a shed, a pool cage or a sprinkler head.

Creeks and soft ground

Rocky Creek and Sweetwater Creek both run through the area, and about 8.39% of the CDP is water. Lots near a creek or a low spot can stay soft after rain. A heavy grinder can rut wet turf, so we look at the ground first and may suggest waiting for a dry spell. If the stump is on a bank, tell us, because the work is done differently there.

Palms, roots and hard surfaces

Palm stumps are fibrous rather than woody. They grind differently from an oak or pine stump, and the roots spread in a mat instead of one deep taproot. Across the neighbourhoods, from Bay Crest Park to Countryway, stumps often sit near a driveway, patio slab or foundation. We check where the roots run before we start, and we keep the cutting wheel clear of anything that should not be touched.

Stump and tree services available in Town 'n' Country

Most calls start with a single stump, but the work around it is often part of the same job. These are the three main services we offer here.

Stump grinding and root grinding

Our core service is Stump Grinding. That covers stump removal by grinding, root grinding along the surface, palm stump grinding, commercial stump grinding for lots and properties, and the hole fill and grindings cleanup afterwards.

Tree removal before the stump

If the tree is still standing, Tree Removal comes first. That includes dead tree removal, palm tree removal, trimming, canopy raising, storm cleanup and removal of trees close to a house. We can often grind the stump on the same visit.

Lot clearing for larger jobs

For a whole overgrown yard or vacant lot, Lot Clearing covers brush and underbrush clearing, forestry mulching, invasive tree removal and bamboo removal. Stumps left behind by the clearing can be ground as part of the work.

What a stump grinding visit looks like

There is no mystery to the visit. Here is the order it follows.

Walking the site

We look at the stump, the surrounding roots, the ground and the access route. We also ask what you plan to put there afterwards. Grass seed, a garden bed and a new fence post all call for different depths, and we adjust to match.

Grinding the stump and surface roots

The operator sweeps the cutting wheel across the stump from side to side, lowering it a little with each pass. Surface roots that would trip a mower or push up through sod are ground out as well. Larger roots that run deeper can be left in the ground, where they slowly rot.

Cleanup and the stump hole

Grinding leaves a mound of wood chips and soil in the hole. We can rake that back in and level it, or haul the grindings away if you would rather bring in clean fill and topsoil. Tell us which you prefer when you book.

How to book stump grinding in Town 'n' Country

Town 'n' Country is served from Clearwater. We do not have an office in Town 'n' Country, and we say so plainly so nobody drives to an address that does not exist. Our crew comes to you.

The quickest way to start is to call (727) 483-5339 or email info@stumpgrindingclearwater.com. Our hours are Monday to Friday, 7:00 AM to 7:00 PM, and Saturday, 8:00 AM to 5:00 PM. We are closed on Sunday and do not offer after-hours service.

A few details help us give you a straight answer: how many stumps there are, roughly how wide each one is, whether it is a palm or a hardwood, and whether the gate and yard are clear. A photo or two is even better. You can also use the Get a Stump Quote button on this site and we will get back to you.

About Town 'n' Country: Town 'n' Country, FL on Wikipedia · Town 'n' Country on Google Maps